31: Titan 575 Owner’s Guide
Always maintain a 50% solution of phosphate-free/low-silicate antifreeze at all
times for adequate heat dissipation, lubrication and protection from freezing.
Major brands are typically low phosphate or phosphate free, and will be labeled
accordingly on the container. It is recommended that you consult the technical
data sheet for the brand of coolant you are using to determine if it meets the low
phosphate requirement. Failure to use a 50% solution of phosphate-free/low-
silicate antifreeze may result in corrosion of the cooling system.
Bleeding Air from Cooling System
It is necessary to remove all of the air from the engine to prevent overheating. If the coolant
has been drained for any reason, it will be necessary to follow the bleed procedure.
When the engine is cold, remove the radiator cap. Fill the radiator until it is to the top of
the filler neck. Start the engine and run in the low rpm position, pump clutch off, and no
vacuum load. Allow the engine coolant to heat up and open the thermostat several times.
As all the air is removed from the system, the level of the radiator should lower below the
internal tubes.
This process should take approximately 5 - 10 minutes. Top off the coolant
and install the cap. In the event you experience a coolant shutdown due to overheat,
allow the machine to cool down and repeat this procedure.
Radiator
Inspect the exterior of the radiator for obstructions. Remove all debris with a soft brush or
cloth. Use care to avoid damaging the core fins.
Fuel Filter
The fuel filter is located between the fuel pump and the fuel tank underneath the vehicle.
Summary of Contents for Titan 575
Page 2: ......
