21: Titan 575 Owner’s Guide
START-UP PROCEDURE
1.
Perform all daily periodic maintenance as specified in this Owner’s Manual.
2.
Connect a garden hose to supply water to the truckmount. If the pump-in feature is
used on your system, push the “PUMP-IN” switch to the “ON” position.
3. Connect the cleaning wand or tool to the length of hose required to perform the
cleaning job.
4.
Start the truckmount with:
a.
The throttle cable in the “IDLE” position.
b.
Pull the choke cable out if the engine is cold.
c.
The “PUMP CLUTCH” switch in the “OFF” position.
5.
After the engine starts, allow the truckmount to run in “IDLE” for 2 - 3 minutes to
warm up. Gradually push on the choke as the engine warms up.
Never clean when the Titan 575 is in the “IDLE” mode. Failure to follow this
caution may result in serious component or engine damage.
6.
Pull the throttle cable all the way out and lock into place.
7.
Press the “PUMP CLUTCH” switch to the “PUMP ON HEAT MODE” position for
carpet cleaning or upholstery cleaning; for high pressure washing, press “PUMP ON
NO HEAT”
8.
Set the “HEAT SELECTOR” valve to the desired position.
a. Set to the “WARM” position for upholstery cleaning.
b. Set to the “HOT” position for carpet cleaning.
9.
If the Automatic Pump-Out is included in your system’s configuration, press the
“AUTO PUMP-OUT” switch to the “ON” position.
Summary of Contents for Titan 575
Page 2: ......
