CTS 400 Flex Owner’s Guide: 42
CLEAN QC FILTER AND ORIFICE
Clean and inspect the in-line quick connect filter and
orifice every 100 hours.
1. Remove the quick connect assembly on the
Carpet/Uph. Cleaning Solution Outlet (see
Figure 14).
2. Hold the hex closest to the panel using a 11/16”
open end wrench and turn the hex assembly for
the quick connect with a 13/16” open end wrench.
3.
Remove the assembly from the dash; the orifice
plate will remain in the assembly.
4.
Remove the filter and orifice (see
5. Clean with a wire brush. Descale
if necessary.
6.
Re-install the assembly.
7. Tighten the assembly.
The amount of torque may vary.
Run the pump to verify there are
no leaks. Re-tighten as required.
The assembly may move in
the dash during removal and
installation. This is normal; using
the 11/16” wrench will minimize
the movement.
Figure 14. Remove Quick
Connect Assembly
Figure 15.
Remove Filter and Orifice
Filter
Orifice Plate
QC Assembly
