Condition Monitoring Unit CMU 1000
Page 42
V03 R21 - 2020/07/09
HYDAC ELECTRONIC GMBH
Mat.-No.:
669749
5.2.3.2 Establishing Connection with GSM Radio Module CSI-F-10
Connect the CMU 1000 for configuring the CSI-F-10 GSM radio module to your
PC as also described in
Chapter 5.2.1 Direct Connection, Chapter 5.2.2 Direct
Connection via HSI Bus or Chapter 5.2.4 TCP Connection
.
Start the HYDAC PC software
CMWIN
In
the
Units
Menu, select the
"CM Manager"
option.
If the
Connection
window does not open automatically, select
"
Connection
" in the menu bar of the CM Manager.
Under
Interface Settings
make the settings necessary for the available
connection type (for configuring the CSI-F-10).
Click on “
OK
“ to apply the settings or “
Cancel
“ to discard these changes. In
either case you will then return to the
Connection
window.
Click
on
Open
to open the selected interface. The opened interface is indicated
by a green dot at the top right.
Select
"
Change
" in the
Pass-through mode
line. The following window opens:
In the drop-down menu, select "
Port I
" and then click on
Switch on
in order to
switch on the pass-through mode.
