Hyd-Mech S-23H, Operation And Maintenance Manual

Page: 9 / 77

Pg 1.2
S23H 2001d
LIFTING THE S-23
The S-23 is shipped with a shipping pallet attached
to the saw. When lifting the pallet with a lift truck make
sure that the load is firmly balanced. The following
photo shows a lift truck lifting the saw and pallet from
the correct side. The pallet length dimension is 84".
Minimum fork length of 72" is recommended to safely
lift the pallet.
WRAPPED FOR SHIPPING
The S-23 is shrink-wrapped for shipping from our
plant. Remove the wrapping from around the saw.
Complete the inspection for signs of damage. The
photo shows the floor mounting plates located at the
corners of the saw. Undo the bolts that hold the saw to the pallet. Retain
these bolts to use for levelling. The larger diameter hole is used for
retaining during shipping and for use with concrete floor anchors. The
smaller diameter, threaded holes at each corner are used for levelling the
saw properly.
REMOVING THE SAW FROM SHIPPING SKID
Lift the right (drive) side of the saw as shown with a lift truck and
place two blocks under the saw as shown. With a lift truck (fork
length 5' min, rated for 2000lbs minimum), lift the saw from the skid
at the FRONT of the machine as shown and place it where required.
Lifting the packaged S-20 Series II with a lift truck.
Bolt holding the saw to the skid (4
places).
Blocks placed under the saw.
Lifting the machine with a lift truck from the front
of machine.