Hyd-Mech S-23H, Operation And Maintenance Manual

Page: 10 / 77

Pg 1.3
S23H 2001d
CUTTING FLUID
The S23 uses a pump and reservoir to circulate the necessary cutting fluid to the blade for maximum blade
life. Your saw blade supplier will be able to provide information to the cutting fluid products that are available for
your needs.
No cutting fluid (coolant) is supplied with the machine. There are two types of coolant available:
- oil based; dilute 1:10 ratio ( one part concentrated coolant to 10 parts water)
- synthetic; dilute as recommended by manufacturer.
LEVELLING THE SAW
Use a machinist's level across the vise table
to level the saw. Adjust the level with the
levelling bolts supplied. Consideration should be
given to the flow of the coolant as it returns to
the coolant trough at the vise end of the saw.
Levelling to give a small incline towards this
area helps to ensure the coolant supply returns
to the container.
Coolant Return (Shown with tank removed)
Wash Down
Coolant Coolant Coolant Coolant Coolant
The power pack with the
door opened.
HYDRAULIC OIL
The S-23H option is supplied with Texaco
Rando HD46 hydraulic oil. Substitutes should be a
#46 hydraulic oil. The power pack and tank is
mounted on the inside of the door found at the idler
side of the infeed table. The tank should be at least
3/4 full at all times.
Hydraulic tank
filler cap is
found
near the pump
& motor
assembly.