Hyco Zen Spa Series, Product Instruction Manual

Page: 22 / 25

9. Draining
• Do not connect to electricity supply without re-filling the tank, checking for leaks
and purging any air out of the system.
• Unplug the unit from the electricity mains.
• Run the boiling tap until it is dispensing cold water.
• Unplug the black lead tap connector (3.5 mm jack) from the back of the heater.
• Turn off water supply. Disconnect the water supply to the tank and tap. Lift the tank
to the sink, turn upside down and drain all the water from the tank.
• When re-installing follow the original installation instructions.
10. Descaling the Tank
A service cartridge can be used to descale the boiling water tank. These are available
from Hyco, please contact our service department for further information.
11. Specification
Supply
230V ~ 50Hz
Power 3/ 6L model 1.55/ 2.84 kW
Tank capacity 3/ 6L model 3/ 6 litres
Max water pressure 0.42 MPa (4.2 bar)*
Min water pressure 0.1MPa (1 bar)
Max tank pressure 0.6 MPa (6 bar)
Ambient operating temperature 5 – 35°C
Approvals CE, WRAS (98°C only)
* If pressure is above 0.42 MPa (4.2 bar) then a pressure reducing valve is required.
Product Description
SPA3L Zen Spa 100°C Tap 3L Boiling and Ambient
SPA6L Zen Spa 100°C Tap 6L Boiling and Ambient
SPA3LUC1 Zen Spa 100°C Tap 3L Boiling and 20L/ h Chilled
SPA6LUC1 Zen Spa 100°C Tap 6L Boiling and 20L/ h Chilled
22