Huvema HU 440 DGH, Operation Manual

Page: 19 / 37

-18-
Additional safety rules
Always keep in mind that:
- the machine must be switched off and disconnected from the power supply during maintenance and repairs,
- clamped workpieces may only be measured when the machine is switched off.
Never lean over the machine, mind loose clothing, ties, jewellery etc. and wear a cap.
Do not remove safety devices or guards. Never use the machine while a guard is open.
Always use safety glasses for machining rough materials.
Burrs and chips should only be removed using a sweeper or other aid, never with your bare hands!
Never leave the machine running unattended.
2. Introduction
This instruction manual has been made in compliance with Legislation according to the Machines directive,
89/392/CEE, and its subsequent amendments.
The instruction manual represents an integral part of the machine. It must be consulted before, during and
after the machine is put into service, as well as whenever it is considered necessary, thereby respecting its
content in each and every one of its parts.
This is the only way in which the fundamental objectives that have been established on the basis of this
manual will be reached, such as accident prevention and making optimal use of the machine features.
Within the framework of this manual, all aspects regarding safety and accident prevention on the job while
using the machine have been considered in every detail, herein highlighting the information that is of greatest
interest to the user.
Attention
Carefully read this manual before installing the machine. The manual must be kept
throughout the machine’s lifetime in a place that is easy to find in the event that it is
needed. In the event that a used machine is sold, the machine shall be sold together with
this manual. In the event that the machine is scrapped, the identification plate and any
other document supplied with the same shall be destroyed.
2.1 Legislation applicable to planning and construction
EN-292-1 Machine Safety. Basic concepts, general design principles.
EN-292-2 Machine Safety. Basic concepts, general design principles.
EN-294 Safety distances to prevent dangerous zones from being reached by the upper extremities.
EN-60204/1 Electrical equipment of industrial machines.
EN-418 Machine safety; emergency stop equipment.
89/392/CEE on “Machine Safety.”
91/368/CEE on “Machine Safety.” (amendment)
93/44/CEE on “Machine Safety.” (amendment)
93/68/CEE on the CE Marking (amendment)
73/23/CEE on “Safety of Electrical Material.”
89/336/CEE on “Electromagnetic Compatibility.”
91/263/CEE on “Electromagnetic Compatibility.” (amendment)
92/31/CEE on “Electromagnetic Compatibility.” (transition period)
3. General machine information
3.1 Machine identification data
See machine label.
Note
In order to request replacement parts, whether they are covered by the warranty or not, always state
the model and serial number of the machine, as well as the name of the part and the code that
appear in the last chapter of exploded views.