Hussmann HGM-1 BS, Installation & Operation Manual

Page: 31 / 70

P/N 0515297_E 4-3
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
HGM Merchandisers
CLEANING EVAPORATION PAN
The condensate water outlet empties into a
limited capacity evaporation pan.
Debris or dirt accumulation inside the condensate
evaporation pan or on the heater coil will
reduce the pan’s evaporation capacity and
cause premature heater failure. The evaporation
pan waste water will overflow and spill onto the
floor if the heater is not properly operating.
Always wear protective eye glasses and gloves
when servicing.
Remove accumulated debris from the
evaporation pan. Wipe down heater coil with a
cloth and warm water. Be sure to remove any
dirt, debris or liquids from the heater coil.
Water introduced during cleaning will cause
the evaporation pan to overflow.
DO NOT FLOOD!
Use only enough water necessary to clean
surface. Water must not drip down the case!
Never use ammonia based cleansers, abrasive
cleansers, or scouring pads.
PRECAUTION
CLEANING PRECAUTIONS
Do not use high pressure water hoses
NEVER INTRODUCE WATER ON SELF CONTAINED
UNIT WITH AN EVAPORATION PAN
NEVER USE A CLEANING OR SANITIZING SOLUTION
THAT HAS OIL BASE (these will dissolve the butyl
sealants) or and AMMONIA BASE (this will corrode the
copper components of the merchandiser)
TO PRESERVE THE ATTRACTIVE FINISH:
Use a water and a mild detergent for the exterior only
Do NOT use a chlorinated cleaner on any surface
Do NOT use abrasives or steel wool scouring pads
(these will mar the finish)
Do not introduce water faster than waste outlet can drain
When Cleaning:
Evaporation Pan is Hot!
and poses risk of bodily injury
–
Always Wear gloves
and protective eye wear when servicing. Turn off
evaporation pan heater, and allow pan to cool.