Hussmann HGM-1 BS, Installation & Operation Manual

Page: 62 / 70

99-18258-I002_A 5/18/2010
Orientation Of End Fixtures
Refer to ”WIRING DIAGRAMS and ORIENTATION” on page 14
End Mullion LED Fixture Mounting Instructions
1. Align the LED light with the mounting clips so that the
LEDs are facing the display case interior. Snap the LED
light into the mounting clips:
a. By placing one end of the LED light into the groove.
b. Gently rotate until the opposite edge firmly locks into
the mounting clip.
NOTE: Ensure that the mounting clips lock into the
outer edge of the LED light aluminum extrusion.
c. Adjust the LED lamp assembly until it is centered on
the Mullion.
2. Continue to “Locking LED Fixture to End Mullion Fixture”
below.
Locking LED Fixture to End Mullion Fixture
1. Using a (#29) 0.136 dia. drill bit, drill a hole through the
bottom LED Lighting fixture through the End Mullion Fixture.
2. Using a Phillips screw driver to start threading the #8 X 1”
long self-tapping screw to hold the clip to the End Mullion
fixture.
3.
Continue to “CONNECTING THE WIRE PLUG ASSEMBLY
TO THE LED FIXTURE WIRES” on page 11.
9
Light