Roll-In
P/N 3053878_B
1-5
HUSSMANN CORPORATION • BRIDGETON, MO 63044-2483 U.S.A.
CASE INSTALLATION
1. Position door alignment guide at the front of the
two end base uprights that mount to the floor.
2. It is important to make sure the end base uprights
are 90° from the back-foam assemblies before
installing the 6 anchor bolts in the concrete. Use a
square as shown below.
3. The door alignment guide positioned at the front
will make sure the two end base uprights are in the
correct location.
4. Drill
½
diameter holes 2
¾
inches deep in the
concrete. Three on each end of the case. Clean out
concrete dust from holes.
5. Install the
½
diameter anchor bolts. Tighten nuts
to secure case to the floor.
GD
F
3.
0
SH
EE
T
SI
ZE
D
NOTES:
1. APPLICABLE STANDARDS / SPECIFICATIONS
ASME Y14.5M-1994, DIMENSIONS AND TOLERANCES
2. KEY PRODUCT CHARACTERISTICS PER EPR-0006 & IDENTIFIED WITH SYMBOL
3. MATERIAL-
4. REF -
K
SHEET 1 OF 12
P/N
REV
THIRD
ANGLE
PROJECTION
UNLESS OTHERWISE SPECIFIED
DIMENSIONS ARE IN INCHES.
R
REVISION HISTORY
REV
ECN
DATE
REVISION DESCRIPTION
REV BY CHKD BY APPR BY
Door Base Plate Installation
18. Mark the holes for the door hinge plates in the door alignment guide (share Pan Dur installation instructions with Jason Trevett)
19. Move the door alignment guide so you can drill the 3/8 diameter holes in the concrete.
20. Install the brass anchors
21. Install the lh and rh end base upright covers.
22. Get the door hinge plates and hardware out of the bag.
23. Take the door alignment guide and turn it around to be able to use it to place the door hinge base plates between the cutouts as shown on figure xxx
24.
Fasten the door hinge base plates to the floor
90°
90°
Door Alignment Guide
Base upright should be tight to alignment guide.
Drill hole through base
upright into floor.
½ bolt hole
locations
½ bolt hole
locations
