Husqvarna TR 650 STRADA 2013, Workshop Manual, Page: 39 / 301

D.9
TR 650 TERRA 2013 - TR 650 STRADA 2013
H11678
1
2
3
MAX
MIN
MAX
MIN
H11679
1
H11680
2
3
H11681
4
Workshop Manual Ed. 09-2012
SETTINGS AND ADJUSTMENTS
Oil level check
The oil level must be checked with the vehicle in vertical position on a flat sur-
face.
- Start the motorcycle and heat the engine until the cooling fan starts; wait for
another 3 minutes and switch off the engine.
- Check the level as follows:
- Undo the cap (1) with the dipstick (2) and remove it from the frame.
- Clean the dipstick (2) with a cloth.
- Place the dipstick (2) in the hole (3) without screwing the cap on.
- Remove the dipstick (2) from the hole (3) and check that the level is be-
tween the two MIN and MAX marks.
- To top up, pour oil into the hole (3); for the type of oil, see the section
“Technical data”.
Never exceed max. level.
Engine oil replacement and cartridge filter replacement
Be careful not to touch hot engine oil.
Drain the oil with WARM ENGINE; proceed as follows:
- Place the motorcycle on its side stand
- Remove the cap (1) with the dipstick
Oil change must be performed in two stages:
Draining oil from tank;
Draining oil from engine
Draining oil from tank:
- Place a 2 litre container under the coupling (2) and then unscrew the screw
(3) and let the oil in the tank drain out completely.
- Once it has drained out, tighten the screw (3) with its corresponding washer.
Draining oil from engine:
- Place a container to collect the oil under the engine.
- Unscrew the screw (4) and let all the oil in the engine drain out completely.
- Once it has drained out, clean the magnetic screw (4), replace the gasket
and refit it on the engine by tightening it to torque.
Fill with oil as described in the relevant paragraph.