Husqvarna TC 85 2020, Owner'S Manual

Page: 54 / 136

11 SERVICE WORK ON THE CHASSIS
52
S03431-10
–
Tighten screws
6
.
Guideline
Screw, bottom triple
clamp M8 15 Nm (11.1 lbf ft)
S03426-10
–
Tighten nut
4
.
Guideline
Nut, steering stem M20x1.5 10 Nm (7.4 lbf ft)
S03426-11
–
Tighten screw
7
.
Guideline
Steering stem clamp
screw M8 20 Nm (14.8 lbf ft)
–
Position fuel tank breather in the steering stem.
S03431-11
–
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
–
Tighten screws
8
.
Guideline
Screw, top triple
clamp M8 17 Nm (12.5 lbf ft)
H00935-17
–
Check the wheel bearing for damage and wear.
» If the wheel bearing is damaged or worn:
–
Change front wheel bearing.
–
Clean and grease shaft seal rings
9
and contact
surfaces
B
of the spacers.
Long-life grease ( p. 127)
–
Insert the spacers.