6 FORK, TRIPLE CLAMP
D00075-10
-
Press the new bearing ring up to the stop with special
tool@).
Tool bracket (58429089000) (
a
p. 287)
Pressing tool (58429091000) (
0
p. 287)
-
Remove lower steering head bearing
0.
-
Remove the seal ring.
-
Grease and mount the new seal ring.
-
Press on the new bearing with a suitable tube as far as it will
go.
Finishing work
-
Install the lower triple clamp. (
!,JI
p. 36)
-
Install front fender. (
!,JI
p. 108)
-
Install the start number plate. (
a
p. 109)
-
Install the front wheel. (
a
p. 113)
-
Check that the wiring harness, throttle cables, and brake and
clutch lines can move freely and are routed correctly.
-
Check the steering head bearing play. (
a
p. 38)
-
Remove the motorcycle from the lift stand. (
il!,!l
p. 12)
-
Mount the handlebar cushion.
6.27
Adjusting the steering head bearing play
40
Preparatory work
-
Raise the motorcycle with a lift stand. (
0
p. 12)
-
Remove the handlebar cushion.
Main work
-
Loosen screws
O.
Remove screw
8.
Loosen and retighten screw @).
Guideline
Screw, top steering
head
M20x1.5
12 Nm (8.9 lbf ft)
-
Using a plastic hammer, tap lightly on the upper triple clamp
to avoid stresses.
-
Mount and tighten screw
8.
Guideline
Screw, top
steering stem
M8
20 Nm (14.8 lbf ft)
Loctite
®
243
™