INSTALLATION
3
Installation Overview
To install your shade, you will need to perform the following four steps:
STEP 1:
Mount the Installation Brackets
STEP 2:
Mount the Battery Wand
STEP 3:
Install the Shade
STEP 4:
Connect the Power Source
STEP 1: Mount the Installation Brackets
■
Your order will include the correct number of
installation brackets for your shade width, as
shown in the table.
➤
There are two sizes of installation brackets,
one for
3
⁄
8
" and
3
⁄
4
" pleat sizes and a larger
one for the 1
1
⁄
4
" pleat size.
➤
For end mounts, two brackets are used up to
the maximum width of 72".
IMPORTANT:
A
1
⁄
2
" spacer block is required for shades using an attached battery wand. The
spacer block is pre-attached to the back of the installation bracket.
■
Should the spacer block become detached, reattach it.
➤
Insert the legs of the installation bracket into the
tabs on the spacer block.
➤
Rotate the installation bracket back, as shown, to
snap it in place.
Tab
Shade
Width
Brackets
Required
12" – 36"
2
36
1
∕
8
" – 72"
3
72
1
∕
8
" – 108"
4
108
1
∕
8
" – 144"
5
144
1
∕
8
" – 174"
6
Installation
Bracket
End Mount
Brackets
1
∕
2
" Spacer Block
1
∕
8
" Shim
