Hunter Douglas PowerView, Installation Operation Care

Page: 15 / 36

INSTALLATION
13
Attach the Universal Valance Clips to the Headrail
With fully recessed inside or ceiling mounts, the universal valance clips must be installed
before mounting the headrail.
■ ■
Attach clips 2" from each end of the headrail.
■ ■
Space additional clip(s) evenly between the two end clips so that they are no more than
36" apart.
■ ■
Do not place the clips where they could interfere with internal headrail mechanisms.
■ ■
If desired, the valance may be positioned
1
⁄
4
" higher by raising the clips one notch up, as
shown in the illustration below right.
Mount the Headrail
IMPORTANT: If placing the battery wand inside the headrail, follow the instructions under
“Place the Battery Wand Inside the Headrail” on page 10.
■ ■
Tilt the headrail so that its back lip slides under the front lip of the end brackets and
intermediate bracket(s).
■ ■
Push the headrail against the back of the end brackets.
■ ■
Check that the front lip of the intermediate bracket(s) is under the front lip of the headrail.
End Bracket
Intermediate Bracket
Standard
Position
Raised Clip =
Higher Valance