Hunter Douglas PowerView, Installation Operation Care

Page: 23 / 36

OPERATION
21
Attach the Valance with Magnetic Valance Clips
■ ■
Align the valance to the headrail.
■ ■
Hold the valance securely from the front side with both
hands.
■ ■
Position the clips to the top-front lip of the headrail until
it is level and in position.
■ ■
Press the valance gently forward, just enough so the clips
adhere to the headrail.
■ ■
Adjust the valance projection:
■ ➤
Inside Mount: Press the valance forward until the face is flush with the opening or
the clips are attached to the headrail.
■ ➤
Outside Mount: Press the valance forward until the clips are attached to the headrail.
To minimize the gap between the valance return and the wall, follow the clip projection
adjustment instructions on page 12.
■ ■
The magnetic valance clips allow for limited valance height adjustments by carefully
sliding the clip up or down while the magnets are adhered to the headrail. The clip’s tabs
rest on the top-front lip of the headrail, keeping the valance level and preventing the
valance from adjusting lower beyond that point.
■ ■
To remove the valance, gently pull the valance up and toward you.
CAUTION: The entire surface area of the magnet inside each clip needs to maintain
clean contact with the front surface area of the headrail at all times.
Attach the Valance with Universal Valance Clips
■ ■
Tilt the valance to insert its bottom notch into the bottom part of the clips.
■ ■
Pulling the valance slightly downward, insert the top notch of the valance into the clips, as
shown.
■ ■
To remove the valance, gently pull the valance downward to release it from the top of the
clips. Rotate the top of the valance toward you. Lift up the valance to release it from the
bottom of the clips.
Macro Aluminum Blinds Insertable Valance
Top
Notch
Bottom
Notch