OPERATION
28
Adjusting the Bottom Limit
■
Press the group button that shade has been joined to.
■
Press and hold the manual control button and then press and release the
▼
CLOSE within
4 seconds. A red LED will turn on to confirm the shade is in limit mode and the shade will
lower automatically and stop to the current bottom limit. If your shade was previously at
the bottom limit it won't move.
■
Use the remote to position shade at the bottom where you would like the new lower limit
to be. The shade will run slower to allow for precise adjustment.
■
Press and hold
■
STOP for 4 seconds to put remote in program mode. The lights on the
remote will flash to indicate it is in program mode.
NOTE:
Make sure a group number is not highlighted.
■
Press and hold the manual control button and then press and release the
▼
CLOSE within
4 seconds. The shade will move slightly and a red LED will turn off confirming the limit is
reset.
■
Press and hold
■
STOP until the lights stop flashing on the remote.
■
Press
▲
OPEN to raise the shade a few inches. Press
■
STOP and
▼
CLOSE to check the
new limit is set.
Install the Standard Bracket Cover (If Ordered)
■
If you ordered standard bracket covers.
Install the bracket covers
by aligning the bracket with the channels in the bracket cover and sliding it
onto the bracket.
Install the Fascia Panel
■
Place the top of the fascia panel into the top
indention of the brackets. Rotate the panel
down and snap it into place.
■
Optional.
Remove the backing from the
tape on the end caps and press onto the
brackets.
➤
Check that the outer surfaces of the
brackets are flush with the ends of the
panel. If not flush, loosen the brackets
and move the bracket over to make it
flush with the panel.
Bracket
Cover
Fascia
Panel
Remove
End Cap
Tape
End Cap
Outer Surface
of the Bracket
Flush with the
Ends of the Panel
