OPERATION
27
Adjust Shade Limits (If Necessary)
NOTE:
Before adjusting the shade limits, cycle the shade at least twice to the fully open and
closed positions to determine whether limits need adjusting.
Adjusting the Top Limit
Basic Reset
The basic reset is used to reset the shade’s top limit only and re-calibrate the shade.
■
Press and hold the manual control button for 6 seconds.
➤
The shade will move slightly to indicate that it has been reset.
■
Release the button and the red LED will blink.
➤
The shade will automatically move up to set the upper limit and then move down to
the lower limit. If this reset doesn't resolve the issues for Standard Bracket, Fascia and
Dual Roller shades then continue to the steps below.
Standard Bracket, Fascia and Dual Roller Shades
■
Raise the shade fully.
■
Disconnect the power and remove the shade. See “Removing the Shade” on page 31.
■
Rotate the shade manually to desired bottom rail position when the shade is fully raised.
■
Verify the top limit screw is screwed in completely. The
screw will tighten counterclockwise for standard roll and
clockwise for reverse roll. The top limit screw shouldn't
turn more than one turn to be completely screwed in.
■
Re-install the idle end.
■
With the idle end installed
, rotate shade until motor is
aligned to insert into the bracket.
CAUTION:
Do not rotate the motor in the tube manually it
will damage the motor.
➤
Standard roll rotate the shade toward the window.
➤
Reverse roll rotate the shade toward the room.
■
Slide the shade up into the bracket until it clicks into place. Gently pull on shade to ensure
it is secure. See “STEP 2 — Install the Shade” on page 17.
■
Reconnect the power and raise the shade to check new bottom bar position, if good, then
lower shade and adjust bottom limit (if necessary).
■
Check and adjust the bottom limit, as needed. See “Adjusting the Bottom Limit” on page
28.
Top
Limit
Screw
Reverse Roll
Standard Roll