INSTALLATION
19
■
Holding the shade to the window, rotate the shade to align the motor end with the
channels on the bracket before installing the idle end then push the idle end of the shade
onto the bracket.
➤
For dual roller shades,
install the rear shade first.
➤
If the motor end does not line up with the channels.
Remove the shade from the
idle end and rotate the shade until motor is aligned to insert into the motor bracket.
CAUTION:
Do not rotate the motor in the tube manually it will damage the motor.
•
Once motor is aligned, reinstall the idle end of the shade onto the bracket.
■
Slide the shade into the motor bracket until it clicks into place. Refer to the images below
for how to orient your shade. Gently pull back on the shade to ensure it is secure.
CAUTION:
Be sure the power cables are not pinched or caught in the brackets.
Angle Shade
Idle
End
Standard Shades
Motor
End
Standard Shade
Motor
End
Fascia Shade
Motor
End
Dual Roller
Shade
Standard Roll
Bottom
Bar
Paper
Banding
Tube and
Shade
Fabric
Reverse Roll
■
Dual Roller Shades
.
Install the front shade (using
the steps on the previous page) in the front of the dual
roller bracket. This shade is a reverse roll shade and
should be oriented as such before installing.
➤
Route the motor cable through the wire retainer to
ensure the cable does interfere with the rear shade.
➤
The front shade is set at the
factory to roll tight when
raised. You can adjust the
top limit to hide the rear
shade roll, if desired. See
“Adjusting the Top Limit” on
page 27 then adjust the
bottom limit, see “Adjusting
the Bottom Limit” on page
28.
Cassette Shades
■
Attach the battery wand clip to the back of the cassette approximately 10" from the
motor side.
➤
Place the bottom of the clip into the lip, squeeze to compress the clip then rotate it up
and hook it into the top channel.
■
Angle the cassette back and then bring the
cassette forward to catch the front lip of the
bracket.
■
Push the cassette back to snap it into the lower
lip on the bracket.
Factory Setting
Top Limit Adjusted to
Hide the Rear Shade Roll
Bracket
Front
Lip
Cassette
Squeeze to
Compress
Clip Installed
Correctly
