OPERATION
25
Testing the Shade
Testing the shade with the manual control button will allow you to ensure the motor and
power source are working correctly. If the shade does not operate, see “Troubleshooting” on
page 29.
■
Press and release the manual control button (located on the bottom
or front depending on your shade type) to test operation. Use a flat
head screwdriver, if necessary. The shade will open, stall, and jog
when reaching the top.
■
Press and release the manual control button to fully lower the shade.
Using the PowerView
®
Remote
First, activate the remote by pulling both plastic tabs from the back battery compartment.
IMPORTANT:
If you have more than one remote see “Adding Additional Remote(s) to the
PowerView
®
Shade Network” in the
PowerView Motorization Remote Control Guide
.
Joining a Shade to a Group
IMPORTANT:
The shade will not operate using the remote until it has been joined to a
group.
1. Press and hold
■
STOP for 4 seconds to put remote in program mode. The lights on the
remote will flash to indicate it is in program mode.
2. Press desired group number (1 – 6) on the remote. The backlight for the group number
selected will flash to show it is selected.
3. Press and hold the manual control button on the shade.
4. While continuing to press the manual button, press
▲
OPEN on the remote. The shade will
move slightly to indicate it has joined the group. Release the manual control button.
5. Press and hold
■
STOP for 4 seconds to exit program mode. The lights will stop flashing.
Manual
Button
Group 1
Group 2
OPEN
CLOSE
Group 3
Group 4
Group 5
Group 6
Favorite
(Shade position)
LEFT ARROW
No function
RIGHT ARROW
No function
STOP
(Press and hold for
programming mode)
