21
Choke Cable Installation
Choke Cable Installation
4. Strip back the shield on each end of the cut wires approximately 1/4 inch
(6.4 mm).
5. Connect the stripped wires of the charger cable to the butt connectors on the
choke cable (red to white and black to black).
6. Securely crimp the wires in the butt connectors.
7. Apply heat over the splice connection shrink insulation to secure the connection.
WARNING!
Use extreme caution when applying heat to the shrink insulation.
8. Connect the terminals on the charger cable to the cranking battery.
Install the Choke Cable
Reduce noise interference (if needed) using the included choke cable.
1. Determine Whether to Install the Choke Cable
If an on-board charger is present and attached to the cranking battery,
install the
choke cable (included) to reduce noise interference in the transducer.
If there is not an on-board charger connected to the cranking battery,
the choke
cable is not required.
2. Install the Choke Cable
Use the following instructions to install the choke cable.
Supplies:
Wire cutter, wire stripper, wire crimper, safety glasses, protective gloves,
and a heating agent.
WARNING!
Disconnect the power source for all related equipment before you
start the installation.
1. Disconnect the on-board charger from the main power source.
2. Disconnect the charger cable from the cranking battery.
3. Use a wire cutter to cut the charger cable between the fork in the output cable
and the fuse holder. The fuse holder should always remain within 7" of the
battery terminals.
Cutting the Charger Cable
cut here
