14
Cable Installation
5. Route the Cables and Connect Power
WARNING!
The power source must be turned off
before you proceed with this installation.
1. Position the first molded anchor point 4-5 inches from
the top of the mount. Secure it with a cable tie. Do not
fully tighten.
CAUTION!
To avoid damaging the cables, apply
cable ties ONLY at the designated anchor points.
2. Rotate the transducer by hand to test the Down, Forward and Landscape Mode
views as illustrated in
MEGA Live Views
to ensure proper slack in the cables.
Your trolling motor mount includes guides to help you position the transducer
correctly (see the illustration
MEGA Live Mode Guides
).
To alternate between Down and Forward views
, rotate the transducer on its
mount using both hands.
To change from Down or Forward view to Landscape Mode
, press the two
release buttons on the hinge until the mount unlocks. Flip the transducer out
until the hinge locks.
To adjust the Landscape Mode angle
, rotate the transducer on its mount
using both hands.
MEGA Live Mode Guides
landscape
landscape
forward
down
Molded Anchor Point
Trolling Motor Mount
6. Rotate the MEGA Live Imaging transducer around the shaft until it is parallel
with the lower unit of the trolling motor (see
Aligning the Transducer
). This
ensures the transducer is pointing in the same direction as the trolling motor.
Aligning the Transducer
7. Fully tighten the screws until the transducer cannot be moved on the shaft.
Hand-tighten only!
