Installing the antenna and radio assembly
1037749-0001 Revision F
27
Installing the reflector bracket and tilt plate
Attach the tilt plate and reflector bracket to the Az/El mount as shown in Figure 9.
1.
Position the Az/El mount so the flat part with five holes faces upward.
2.
Place the reflector bracket against the Az/El mount.
See Figure 9 and Figure 10.
3.
Place the tilt plate over the round opening in the reflector bracket.
4.
Rotate the tilt plate so that each of the five holes in the Az/El mount is aligned
with a hole in the tilt plate. (There are extra holes in the tilt plate that will not
line up with holes in the Az/El mount.)
Figure 9: Attaching the reflector bracket and tilt plate
5.
Insert five carriage bolts through the tilt plate and into the holes in the Az/El
mount.
6.
From the opposite side of the reflector bracket, place a hex flange nut on each
bolt and tighten the nuts lightly, only until snug.
The reflector bracket should rotate freely between the Az/El mount and the
tilt plate.
