Installing the antenna and radio assembly
1037749-0001 Revision F
35
2.
Position the clamp half that has two threaded holes against the polarizer-TRIA
interface, as shown in Figure 18 (left photo).
Figure 18: Attaching the clamp that holds the polarizer in place
3.
Position the other clamp half (with holes that are not threaded) against the
clamp half that is already in place.
4.
Start each screw (spring-loaded Allen screws) by hand, being careful not to
cross-thread them.
Because the screws are long, they can easily be cross-threaded if they are
misaligned. If the screw does not turn easily when first inserted, back it out
and start again.
5.
Use a 7/64 inch Allen wrench—
do not use a power driver
—to alternately
tighten the two screws. When you hear a click, the screw is fully tightened
and should not be turned further.
