Installing the antenna and radio assembly
1037749-0001 Revision F
29
2.
Insert four carriage bolts (5/16 inch × ¾ inch) into the holes in the reflector
and through the corresponding holes in the reflector bracket, as shown in the
illustration.
Figure 11: Attaching the antenna reflector
3.
Insert the Phillips head screw through the hole near the bottom of the
reflector and into the corresponding hole in the reflector bracket—but do not
tighten this screw yet.
4.
From the back of the reflector bracket, secure the four bolts with four ½ inch
hex flange nuts and tighten the nuts.
Note:
Make sure the carriage bolts are firmly seated before tightening the nuts.
5.
Tighten the Phillips head screw.
