PD2795 02/2017
Page 5
B.
ON/OFF Mode
: All controlled lighting will turn OFF based on the settings. The controlled lighting will be OFF as long
as there is sufficient daylight to maintain the desired minimum task light level.
Design Level
: The target minimum foot candle level at the task work surface.
At Sensor
: Indicates the current amount of daylight visible to the daylight sensor. Touch <
Get Level
> at any time
to refresh the daylight level.
At Task
: The amount of light in foot candles as read by a light meter placed at the task surface. Take this reading
with the indoor lighting turned OFF.
Dead Band (%)
: Provides a band between ON and OFF to prevent unwanted cycling of the load. Typically a
setting of 5% works well.
Make changes as needed. Touch the <
Accept
> button to save the changes or
touch the <
Back
> button to exit WITHOUT saving the changes.
C.
Step Relay Mode
: High, low, OFF switching control based on the
Primary/Secondary setting for the controlled relay(s)
D.
Full Dimming Mode
: Full range dimming in response to daylight.
Design Level
: The target minimum foot candle level to be maintained at the
work surface. Enter the specified foot candle level.
At Sensor
: Indicates the current amount of daylight visible to the daylight
sensor. Touch <
Get Level
> at any time to re read the daylight level.
At Task
: The amount of light in foot candles as read by a light meter placed at the task surface. Take this reading
with the electric lighting turned OFF.
NOTE
: Make adjustments to the Design Level until the desired foot candle reading is achieved on the light meter
at the task surface.
E.
Test Mode
: This is the factory default setting for Zone 1. Test mode causes the controlled lighting to react quickly to
bright and dim light such as passing the beam of a flashlight across the daylight sensor.
7.
Preset Settings
: Touch to display the preset setup page. Use the Preset Select pull down to choose which preset (1 - 16) this
button will affect.
Note
: the factory default programming, sets Preset 1 to 100%, Preset 2 to 75%, Preset 3 to 50%, and Preset
4 to 25% for all dimmers.
NOTE
: The “Include” setting determines if this preset will affect the associated dimmer or relay. If the
box is not checked, this preset will NOT change this dimmer or relay when activated.
Fade Time
: The fade time for transitions between presets can be set between 1 second and 18 hours. The factory default
fade time is 5 seconds. Use the sliders or type in the box to change the fade time for this preset.
Dimmers
: Use the slider or type in the box to set the desired dimmer level for each dimmer.
Relays
: Use the controls to set if the relay will be turned ON or OFF when this preset is activated.
After all settings have been selected, touch the <
Save
> button at the top of the screen. A <
Test
> button is also provided at the top
of the screen. This button will activate the current preset exactly as if the preset button on the actual switch is touched.
NOTE
: Touching the <
Test
> button immediately after saving a preset will have no affect since the lighting will already be set to the
levels defined for the current preset.
