Pub. 42004-550A
Elemec3
Console Manual
—Version 3.0
Page 50 of 114
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550A.docx
09/20
Outputs Tab
Click the I/O controller properties
O
UTPUTS
tab to configure the output contacts of the I/O controllers.
The E3 Console sequentially assigns each output a numeric address in an X.Y format, where X is the I/O
controller address and Y is the contact number on the I/O controller PCBA.
Figure 52. I/O Controller Output Contact Definitions
The output property fields appear from left to right across the outputs tab. Configure the relay state in
column two to enable the other fields in the row to define the output.
Description
—user-defined unique description of the output.
Relay Normal (idle) State
—specifies the relay’s idle state; disabled, normally on, or normally off.
Follow Audio
—the relay activates only while the event audio is broadcasting. (The output will activate
regardless of audio broadcast when deselected.)
Behavior
—the output behavior of the relay as described in the Output Behaviors section below.
Inhibit Groups
Inhibit groups allow for selectively inhibiting inputs to the
Elemec3
system. Configure system inputs to
trigger an inhibit group that inhibits all inputs in the group. Click
I
NHIBIT
G
ROUPS
to access the
I
NHIBIT
G
ROUP
C
ONFIGURATION
screen from the
I/O
C
ONTROLLERS
S
UMMARY
screen (see Figure 47).
