Pub. 42004-550A
Elemec3
Console Manual
—Version 3.0
Page 67 of 114
P:\Standard IOMs - Current Release\42004 Instr. Manuals\42004-550A.docx
09/20
Auxiliary Inputs #1–5 Audio Input Properties
Select an
A
UX
I
N
checkbox from the
S
OURCES
E
NABLED
to configure the audio input properties.
A
UX
I
N
#2
is not available if
INSERT ONE
is enabled and
A
UX
I
N
#3
is not available if
INSERT TWO
is enabled.
A
UX
#4
and
A
UX
#5
are disabled in A+B and N+1 configurations.
Figure 69. Auxiliary Interface Audio Input Properties
Insert Required?
—the
A
UX
interface requires an insert.
Enable inserts on the
G
LOBALS
panel from the
S
YSTEM
P
ROPERTIES
screen if they are used by any
of the enabled audio input sources (see Sources Enabled section).
Allow Attenuation ?
—applies attenuation to the input. (Configure the attenuation setting on the Global
Settings panel on the
S
YSTEM
P
ROPERTIES
screen.)
Event (Aux #1 only)
—event initiated by the Aux #1 PTT contact.
Volume Level
—gain of the selected Aux input.
Max Duration
—maximum duration of an auxiliary input broadcast.
Start Trim
—recording delay at the beginning of a record/playback event (seconds).
Stop Trim
—amount of playback audio removed at the end of the playback (seconds).
