HSB Gamma 120-ZSSD, Original Assembly And Maintenance Instructions, Page: 19 / 22

Maintenance
FM 169 A&M Instr. for Gamma type Z..D Rev.01 2018-06-11
17
distributed by
Lubrication points on
linear units size 90
and 120
Figure 4: Lubrication points (1) or (2) on carriage
The lubrication points are located on the front faces (1) or on the sides
(2) of the guide carriages (4 x per carriage). For size 120, the side
lubrication point (2) is preferred as the two carriages can run very
closely together and therefore a collision between the front face
lubrication connections can occur.
The lubrication plan outlined below applies for the lubrication points.
Size 160 to 280
Figure 5: Lubrication points (1) on the carriage
The lubrication points (1) are on the two long sides of the carriage and
each supply two guide carriages (meaning it is only possible to
relubricate from one side).
The lubrication plan outlined below applies for the lubrication points.
Lubrication method Lubrication should take place as far as possible while in motion so that
the grease is distributed and no pressure builds up.