Assembly and Alignment
FM 169 A&M Instr. for Gamma type Z..D Rev.01
2018-06-11
11
distributed by
6
Assembly and Alignment
The linear unit can be mounted as follows:
With screws in the sliding blocks
With screws in the factory-fitted threaded rails
Only mount the linear unit onto a flat surface. Standard parallelism
<0.2 mm/1000 mm.
Mounting the linear unit using the threaded rails is recommended
for the following situations:
For highly dynamic applications
For just 2 fixing points on the linear unit
6.1
Screw linear unit into place from underneath
Figure 2: Sliding blocks (1) in the groove on the underside of the basic profile
Secure the linear unit using fastening screws from below using the
sliding blocks or the threaded rails in the basic aluminium profile
(Figure 2).
Proceed as follows:
1.
Align the linear unit.
2.
Align the sliding blocks (1) / threaded rails.
3.
Screw the linear unit into place
(for tightening torques refer to section 3).
Summary of Contents for Gamma 120-ZSSD
Page 2: ......