Table 1: SN3600B Rack Mount Kit hardware
Item
Description
Two rear mounting brackets
A right inner rail and a right
outer rail
A left inner rail and a left outer
rail
Fourteen #8-32 x 3/16-inch
Phillips panhead screws with
thread lock.
Fourteen #8-32 x 5/16-inch
Phillips panhead SEMS
screws.
Ten #10-32 x 1/2-inch Phillips
panhead screws with captive
star lock washers
Eight #10 alignment washers
Eight #10 adapter washers
Two 1/4-20 hex nuts with
captive star lock washers
Two 1/4-inch flat washers
CAUTION:
For proper airflow, the SFP+ media side of the device port side must face the rear of the rack. This
allows cool air to enter the front of the rack and exit from the rear.
To install the switch in a rack using the Rack Mount Kit:
1.
Verify that the required parts and hardware are available. (See
SN3600B Rack Mount Kit
hardware
.)
2.
Place the switch on a flat surface and attach each inner rail to the switch using five flat-head screws
as shown in
Attaching the inner rails
. The rails are labeled Left and Right to designate the left side
and right side of the switch as viewed from its non-port side.
Setup and install
7
