Serial port specifications
The serial port is located on the port-side of the switch and uses an RJ-45 connector for the serial port.
An RJ-45 to DB9 adapter cable is supplied with the switch.
NOTE:
To prevent damage, keep the cover on the port when not in use.
Before connecting the switch to a fabric or IP network, you must connect to a workstation through the
serial port and configure the switch IP address. The serial port’s parameters are fixed at 9600 baud, 8
data bits, and no parity, with flow control set to None.
Table 11: Serial cable pinouts for the HPE StoreFabric SN3600B 32Gb FC Switch
and HPE StoreFabric SN6600B 32Gb FC Switch
Pin
Signal
Description
1
Not supported
N/A
2
Not supported
N/A
3
UART1_TXD
Transmit data
4
GND
Logic ground
5
GND
Logic ground
6
UART1_RXD
Receive data
7
Not supported
N/A
8
Not supported
N/A
AG default port mapping
Table 12: HPE StoreFabric SN3600B 32Gb FC Switch AG default port mapping
Total ports
F_Ports
N_Ports
Default port mapping
24
0–15
16-23
0–1 mapped to 16; 2-3 mapped to 17; 4-5 mapped to 18;
6-7 mapped to 19; 8-9 mapped to 20; 10-11 mapped to 21;
12-13 mapped to 22; 14-15 mapped to 23
Table 13: HPE StoreFabric SN6600B 32Gb FC Switch AG default port mapping
Total ports
F_Ports
N_Ports
Default port mapping
64
0–39
40–47
0–4 mapped to 40; 5-9 mapped to 41; 10–14 mapped to
42; 15–19 mapped to 43; 20–24 mapped to 44; 25–29
mapped to 45; 30–34 mapped to 46; 35–39 mapped to 47
Serial port specifications
35
