C-16
Compaq StorageWorks SSL2000 Series Library Maintenance and Service Guide
Adding a PTM Extrusion
This section describes how to add an extrusion to extend the PTM. To add an extrusion, you
must first remove the PTM, the elevator car, and the bottom pulley assembly.
To add an expansion module:
1.
Remove the PTM (if already installed).
2.
Remove the elevator car (described later in this section).
3.
Remove the bottom pulley assembly (described later in this section).
4.
Move the location stop pin to the lowest PTM extrusion (
Figure C-14).
cc0033
1
Figure C-14. Location stop pin
