Removal and replacement procedures 122
RAID controller super capacitator (optional)
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the
internal system components to cool before touching them.
To install the component:
1.
Power down the server (on page
20
).
2.
Disconnect all peripheral cables from the server.
3.
Remove the access panel (on page
21
).
4.
Remove the fan duct (on page
69
).
5.
Remove the left or center riser cage (on page
70
).
6.
Install the RAID controller super capacitator to the card.
a.
Install the clip on the remote mount board.
b.
Align the 3 screws and secure the clip to the remote mount board using the 3 screws.
c.
Attach the CVPM05 module to the remote mount board by pressing the CVPM05 module into the
clip on the remote mount board until the module clicks firmly into place.
d.
Connect the CVPM05 module to the MegaRAID adapter by connecting the module interface
cable connector (the larger connector) into the Cachevault power module. Connect the board
interface cable connector (the smaller connector) into the connector on the RAID adapter.
NOTE:
For detailed installation instructions, please refer to the Broadcom website.
7.
Install the RAID controller super capacitator card into the middle slot (PCIe add-on card slot 2 or 5)
on the riser cage.
