Configuring a fixed router ID for local BGP routing process
Syntax:
bgp router-id
router-id
no bgp router id
Configures a fixed router ID for the local Border Gateway Protocol (BGP) routing process. To remove the fixed
router ID from the running configuration file and restore the default router ID selection, use the
no
form of this
command.
The
bgp router-id
command is used to configure a fixed router ID for a local BGP routing process. The router
ID is entered in the IP address format. Any valid IP address can be used.
Specifying the networks to be advertised by the BGP routing process
Syntax:
[no] network
ipv4/mask
[route-map
route-map-name
]
To specify the networks to be advertised by the Border Gateway Protocol (BGP) routing processes, use the
network
command. To remove an entry from the routing table, use the no form of this command.
BGP networks can be learned from connected routes, from dynamic routing, and from static route sources. The
maximum number of network commands you can use is determined by the resources of the router, such as the
configured NVRAM or RAM.
Adjusting BGP network timers
Syntax:
[no] bgp timers
keep-alive
hold-time
To adjust BGP network timers, use the
bgp timers
command in router configuration mode. To reset the BGP
timing defaults, use the no form of this command.
Re-enabling state contained within nodes of BGP processes
Syntax:
[no] enable
disable
Re-enables the state contained within this node and all child nodes of the Border Gateway Protocol (BGP)
process. The
disable
command disables the state contained within this node and all child nodes. The default is
for the state to be disabled.
358
Aruba 3810 / 5400R Multicast and Routing Guide for ArubaOS-
Switch 16.08
