type-2
Sets the metric type of an OSPF external route to type 2.
Setting the tag value
Syntax:
set tag
value
no set tag
value
Sets the tag value of the route. The
no
form of the command deletes the set clause from the sequence.
value
Value of the route tag. This is an integer value between 0 and the maximum number supported by the routing
switch.
Route policy overview
The route table in a routing switch contains routing paths to IP destinations. The traditional sources of the routing
paths are:
• Directly connected destinations (no router hops)
• Static routes (manually configured by a network administrator)
• Routing protocols such as RIP or OSPF
Route policy provides an additional method for controlling entries in the route table. This approach applies
predetermined policies to define how the routing switch accepts routes from peers, propagates routes to peers,
and redistributes routes between different protocols. Route policy can often provide finer control and greater
flexibility over route table entries than traditional methods.
Route policy is embodied in route maps, which are used to match destination routes according to IP addresses
and other parameters. Optional set statements allow changing properties of the route depending on the match.
Typical uses for route policy include filtering and redistribution of routes.
Figure 46: Route policy components
Configuring route policy
The steps in configuring a route policy are:
274
Aruba 3810 / 5400R Multicast and Routing Guide for ArubaOS-
Switch 16.08
