4.
Open the PCI card retention clamp, press the retention clamp levers down to unsnap, and then
rotate them up (1), as shown:
Figure 4-40
Installing a PCI card
5.
Remove the PCI slot cover (2).
6.
Align the keyed components of the PCI card with the slot, and then firmly seat the card in the slot
(3).
7.
Close the PCI retention clamp by rotating the clamp downward and pressing the two green clamp
levers from the rear panel of the chassis (4).
8.
Connect the auxiliary power cable, if necessary.
9.
Reinstall any PCI support brackets and the workstation side access panel.
SAS hard drive
This section describes how to remove and install a SAS hard drive.
Removing a SAS hard drive
NOTE:
Each workstation hard drive bay can be configured at the factory to hold three small form factor
hard drives instead of two standard size drives. To obtain the option kit documentation for removal and
replacement of small form factor hard drives, refer to the
HP xw Workstation series - Small form factor
bay converter and hard drive installation
user guide, located at:
http://www.hp.com/support/xw6600
manuals
.
86
Chapter 4 Removal and replacement procedures
ENWW
Summary of Contents for Xw6600 - Workstation - 2 GB RAM
