Screen message
Probable cause
Recommended action
210—Mismatched memory
(AMBs) detected
Different memory module types are
matched
Ensure that compatible memory module types are used
in matched pairs.
211—Memory warning
condition detected
Improper or defective memory module Replace the memory module.
212—Failed Processor
Processor has failed to initialize.
1.
Reseat the processor in its socket.
2.
If the processor does not respond, replace it.
213—Incompatible Memory
Modules
A memory module in memory socket
identified in the error message is
missing critical SPD information, or is
incompatible with the chipset.
1.
Verify proper memory module type.
2.
Insert the DIMM in another memory socket.
3.
Replace module with a DIM conforming to the
SPD standard.
214—DIMM Configuration
Warning
DIMMs are not installed correctly (not
paired correctly)
See the service label on the workstation access panel
for the correct memory configurations, and reseat the
DIMMs accordingly.
216—Memory Size Exceeds
Maximum Supported
The amount of memory installed
exceeds that supported by the
hardware
1.
Verify how much memory your system supports.
2.
Remove the excess memory.
301—Keyboard Error
Keyboard failure.
1.
Reconnect the keyboard with the workstation
powered off.
2.
Check the connector for bent or missing pins.
3.
Be sure that none of the keys are pressed.
4.
Replace the keyboard.
303—Keyboard Controller
Error
I/O board keyboard controller is
defective or is not set properly
1.
Reconnect the keyboard with workstation
turned off.
2.
Replace the system board.
304—Keyboard or System
Unit Error
Keyboard failure.
1.
Reconnect the keyboard with workstation turned
off.
2.
Be sure that none of the keys are pressed.
3.
Replace keyboard.
4.
Replace system board.
510—Splash Screen image
corrupted
Splash Screen image has errors.
Update system BIOS.
511—CPU. CPU A, or CPU B
Fan not detected
Fan is not connected or is defective
1.
Reseat the fan cable.
2.
Reseat the fan.
3.
Replace the fan.
512—Chassis, rear chassis, or
front chassis fan not detected
Fan is not connected, might have
malfunctioned.
1.
Reseat the chassis, rear chassis, or front chassis
fan cable.
2.
Reseat the chassis, rear chassis, or front
chassis fan.
3.
Replace the chassis, rear chassis, or front
chassis fan.
513—Memory fan not
detected
Missing or disconnected memory fan
1.
Ensure the memory fan is installed.
2.
Ensure proper memory fan connections.
Table 5-18
POST error messages (continued)
ENWW
POST error messages 131
Summary of Contents for Xw6600 - Workstation - 2 GB RAM
