To establish a setup password using the Computer Setup (F10) menu:
1.
Power on or restart the workstation.
2.
As soon as the computer is powered on, press and hold
F10
until you enter the Computer Setup
(F10) Utility. Press
Enter
to bypass the title screen, if necessary.
If you do not press
F10
at the appropriate time, you must restart the workstation, and then press
and hold
F10
again to access the utility.
If you are using a PS 2 keyboard, you might see a keyboard error message. Disregard it.
3.
Select
Security>Setup Password
and then follow the onscreen instructions.
4.
Before exiting, select
File>Save Changes
and then select
Exit
.
Establishing a power-on password using workstation setup
Establishing a power-on password through the Computer Setup (F10) Utility prevents access to the
workstation when power is connected, unless you specify the password. When a power-on password
is set, the Computer Setup (F10) Utility presents Password Options in the Security menu. The password
options include Network Server Mode and Password Prompt on Warm Boot.
When Network Server Mode is disabled, you must specify when the password when the workstation is
powered on when the key icon appears on the monitor.
When Password Prompt on Warm Boot is enabled, the password must also be entered each time the
workstation is rebooted.
When Network Server Mode is enabled, the password prompt is not presented during POST, but any
attached PS 2 keyboard remains locked until you enter the power-on password.
To enable Network Server Mode, you set a power-on password. The option to set this password is
available under Advanced>Password Options. This option enables the system to boot without requiring
the power-on password, but the keyboard and mouse are locked until you enter the password. The
keyboard LEDs rotate constantly when the system is in locked mode.
To establish a power-on password through the Computer (F10) menu:
1.
Power on or restart the workstation.
2.
As soon as your workstation is powered on, press and hold
F10
until you enter the Computer Setup
(F10) Utility.
Press
Enter
to bypass the title screen, if necessary.
If you do not press
F10
at the appropriate time, you must restart the workstation, and then press
and hold
F10
again to access the utility.
If you are using a PS 2 keyboard, you might see a keyboard error message. Disregard it.
3.
Select
Security>Power-On Password
and then follow the onscreen instructions.
4.
Before exiting, select
File>Save Changes
and then
Exit
.
Entering a power-on password
1.
Restart the workstation.
2.
When the key icon appears on the monitor, enter the current password, and then press
Enter
.
Type carefully. For security reasons, the characters you enter do not appear on the screen.
38
Chapter 3 System management
ENWW
Summary of Contents for Xw6600 - Workstation - 2 GB RAM
