4.
After removing the optical drive (1), if you plan to install another drive, remove only the four guide
screws from the drive casing (2).
Figure 5-39
Removing the optical drive screws
Installing an optical drive (minitower configuration)
1.
Disconnect power from the system (
Predisassembly procedures on page 57
), remove the side
access panel (
Removing the side access panel on page 61
), and then remove the front bezel
(
Removing the front bezel on page 65
).
2.
Insert the four black metric M3 guide screws into the drive casing (1).
Figure 5-40
Installing the optical drive
3.
Align the screws with the grooves in the drive bay, and then gently slide the drive into the
workstation until it snaps into place (2).
ENWW
Removing and replacing components
89
