HP Vectra XU 6/XXX, User Manual

Page: 110 / 168

4 Troubleshooting Your PC and Using the Setup Program
Using the HP Setup Program
98 English
Using the Start-Up
Center
The Start-Up Center lets you choose which system devices the
computer can start (boot) from. Some options will not be available if you
selected
Operating System . . . Microsoft Windows NT
,
OS/2
,
or
Other
.
The
Priority Selected
items are for information only and cannot
be changed.
Parallel Ports and
Serial Ports
Use these options to select a combination of I/O address and IRQ
channel for the parallel port and for the serial ports.
To configure a parallel port mode, highlight
Parallel Port Mode
and
select
Centronics
,
EPP
, or
ECP
.
NOTE These options may not be available if Windows 95 is installed on your
computer.
HP Vectra PC Setup xxx.xx.xxx.xx F1=Help On/Off
Start-Up Center
Control
Start from Flexible Disk . . . Enabled/Disabled
Start from CD-ROM . . . . . . . Enabled/Disabled
Start from Hard Disk . . . . . Enabled/Disabled
Start with Network . . . . . . Enabled/Disabled
Protocol . . . . . . . . . . . Not used/Novell/Microsoft
Priority Selected
Priority 1 . . . . . . . . . . . Flexible Drive
Priority 2 . . . . . . . . . . . IDE Hard Disk
Priority 3 . . . . . . . . . . . SCSI Hard Disk
Priority 4 . . . . . . . . . . . Network
Parallel Port . . . . . . . . . . . Parallel 1 (378h, IRQ7)
Parallel Port Mode . . . . . . . . Centronics/EPP/ECP
Serial Port A . . . . . . . . . . . Serial 1/2/3/4/Off
Serial Port B . . . . . . . . . . . Serial 1/2/3/4/Off