HP Surestore Tape Library Model 2/15, User Manual

Page: 81 / 114

4-31
Library Operation
Running an Internal Test
L
ib
r
ar
y
O
p
er
at
io
n
Running an Internal Test
1 2
➞
ADMIN*
➞
PSWD 000 000 000
➞
TEST*
WARNING
Class II laser light is generated in this library. If operating the library
with access panels removed or with less than three tape magazines
installed with the interlocks disabled and the front door open, do not
stare into the light from the bar code reader.
Laser light warning labels are located adjacent to the side access
panels and the top access panel.
CAUTION Some diagnostic tests, such as Exchange Demo, may place tape cartridges in
unexpected locations, which can cause problems with the software
application being used.
NOTE
Some diagnostic tests can only be run through the SCSI interface. Refer to
Digital Linear Tape Drive and Library SCSI-2 Command Reference (HP
part number 5960-7674) for information about these tests.
To run self-diagnostic tests:
1. Verify that the drive status displays (if not, press
CANCEL
until it does).
2. Press
NEXT
until
ADMIN*
displays, then press
ENTER
.
3. Enter the three-part numerical password (see “Entering the
Administration Menu Password” on page 4-7).
4.
INFO*
displays. Press
NEXT
or
PREV
until
TEST*
displays, then press
ENTER
.
5. Press
NEXT
until test to run displays, then press
ENTER
.
6.
NUM LOOPS #
, where “#” is flashing and represents the number of test
cycles the test will go through.
7. Press
NEXT
to specify the number of cycles, then press
ENTER
to start the
test.
NOTE
Press
CANCEL
at any time to abort a test.
TEST CANCEL - WAIT
displays
while the current test loop completes.