HP ProLiant DL140 Server Setup and Installation Guide
12
To install a DIMM onto the system board:
1.
Access internal server components. Refer to the “Accessing Internal Server Components”
section earlier in this chapter.
2.
Open the DIMM socket latches.
3.
Align the key slot in the bottom edge of the DIMM with the tab in the DIMM socket.
IMPORTANT: Misaligned DIMMs do not seat.
4.
Press down firmly on the DIMM while pushing the latches inward until the latches snap into
place.
5.
Reverse the procedures performed in the “Accessing Internal Server Components” section
earlier in this chapter.
Installing an Expansion Board
Server I/O can be expanded by installing PCI or PCI-X expansion boards. The system supports
one full-length PCI or PCI-X expansion board.
Observe the following guidelines when installing expansion boards:
•
Expansion boards installed in the server must be PCI or PCI-X, 3.3 V, 32 or 64 bits wide, and
33, 66, 100 or 133MHz frequency.
•
Use either half length or full-length expansion boards.
Refer to www.compaq.com/quickspecs for supported PCI and PCI-X option kits. To install an
expansion board, complete the procedures described in the following subsections.
Removing the PCI Riser Board Assembly
To remove the PCI riser board assembly:
CAUTION: To avoid damaging the system or expansion boards, remove all AC
power cords before installing or removing an expansion board. When the front panel
power switch is in the Off position, auxiliary power is still connected to the PCI
expansion slot and may damage the card.
1.
Access internal server components. Refer to the “Accessing Internal Server Components”
section earlier in this chapter.
2.
Lift the PCI riser board assembly from the server chassis.
NOTE: If the PCI slot retention screw located near the slot cover is installed, it must be removed
prior to removal of the PCI riser board.
All manuals and user guides at all-guides.com
