40
HP ProLiant DL580 Generation 3 Server Maintenance and Service Guide
IMPORTANT: HP recommends troubleshooting the system using
port 85 codes before replacing the system board. Refer to
"Troubleshooting the system using port 85 codes (on page
84
)" for a list
of codes and troubleshooting procedures.
1.
Power down the server ("Powering down the server" on page
18
).
2.
Remove all media drives ("Removing a media drive" on page
23
) and media
drive blanks ("Removing a media drive blank" on page
23
).
3.
Remove all hard drives ("Removing a hot-plug SCSI hard drive" on page
50
)
and hard drive blanks ("Removing a hard drive blank" on page
49
).
4.
Remove all memory boards ("Removing a memory board" on page
75
,
"Removing a memory board (non-hot-plug)" on page
73
) and memory board
blanks.
5.
Remove the processor module ("Removing the processor module" on page
24
).
6.
Extend or remove the server from the rack ("Removing the server from the
rack" on page
19
).
7.
Remove the access panel ("Removing the access panel" on page
19
).
8.
Remove the media board ("Removing the media board" on page
44
).
9.
Remove the SCSI backplane ("Removing the SCSI backplane" on page
45
).
10.
Remove all system fans ("Replacing hot-plug fans" on page
60
).
11.
Remove all expansion boards ("Removing a non-hot-plug expansion board"
on page
33
, "Removing a PCI-X Hot Plug expansion board" on page
57
).
12.
Remove the PCI-X Hot Plug basket ("Removing the PCI-X Hot Plug basket"
on page
32
), if installed.
13.
Disconnect the cable from the PCI-X Hot Plug mezzanine board, if installed.
14.
Remove the system cage ("Removing the system cage" on page
20
).
15.
Unlock the latch and open the lever.
