124
HP ProLiant DL580 Generation 3 Server Maintenance and Service Guide
5.
Disconnect all cables from the media board.
6.
Remove the media board ("Removing the media board" on page
44
).
7.
Loosen the screw, and slide the USB cable connector up to remove the cable
assembly from the server.
To replace the component, reverse the removal procedure.
Power switch cable assembly
1.
Power down the server ("Powering down the server" on page
18
).
2.
Extend the server from the rack.
3.
Remove the access panel ("Removing the access panel" on page
19
).
4.
Remove the front bezel ("Removing the front bezel" on page
21
).
5.
Disconnect all cables from the media board.
6.
Remove the media board ("Removing the media board" on page
44
).
7.
Remove the USB cable assembly.
8.
Insert a flat screwdriver into the power switch cable housing next to the
middle two LEDs and pry the housing from the chassis.
