Hardware options installation 49
1.
Power down the server (on page
27
).
2.
Extend the server from the rack, if applicable ("
Extend the server from the rack
" on page
28
).
3.
Remove the access panel ("
Removing the access panel
" on page
29
).
4.
Remove the protective cover on the server bezel from the front of the diskette drive bay.
5.
Slide the diskette drive into the diskette drive bay.
6.
Tighten the thumbscrew.
7.
Secure the diskette drive cable to the diskette drive cable connector on the SCSI backplane or the
SAS backplane.
Hot-plug tape drive option
NOTE:
This feature applies only to SCSI models.
1.
Remove the existing hard drive blank or hard drive from the upper-left drive bay ("
Removing a hot-
plug SCSI hard drive
" on page
45
).
Summary of Contents for ProLiant DL380 Generation 4
Page 98: ...Troubleshooting 98 ...
Page 104: ...Troubleshooting 104 ...
Page 110: ...Regulatory compliance notices 110 Power cord statement for Japan ...
