To replace the component:
1.
Install the spare system board.
2.
Install all components removed from the failed system board.
3.
Install the access panel.
4.
Install the power supplies.
5.
Power up the server.
After you replace the system board, you must re-enter the server serial number and the product ID:
1.
During the server startup sequence, press the
F9
key to access UEFI System Utilities.
2.
Select
System Configuration > BIOS/Platform Configuration (RBSU) > Advanced Options >
Advanced System ROM Options > Serial Number
, and then press the
Enter
key.
3.
Enter the serial number and press the
Enter
key. The following message appears:
The serial number should only be modified by qualified service personnel. This value should always match
the serial number located on the chassis.
4.
To clear the warning, press the
Enter
key.
5.
Enter the serial number and press the
Enter
key.
6.
Select Product ID. The following warning appears:
Warning: The Product ID should ONLY be modified by qualified service personnel. This value should
always match the Product ID located on the chassis.
7.
Enter the product ID and press the
Enter
key.
8.
To confirm exiting System Utilities, press the
F10
key.
9.
The server automatically reboots.
60
Removal and replacement procedures
Summary of Contents for ProLiant DL360 Gen10
