Hardware options installation 75
b.
Disconnect each power cord from the server.
3.
Do one of the following:
o
Extend the server from the rack (on page
17
).
o
Remove the server from the rack (on page
20
).
4.
Remove the access panel (on page
21
).
5.
Remove the PCI riser cage (on page
23
).
6.
Install the SSD module on the M.2 SSD enablement board:
a.
Insert the SSD module into the SSD slot at a 45 degree angle, and then gently press it down against
the M.2 SSD Enablement board.
b.
Secure the SSD module to the M.2 SSD enablement board with a screw.
c.
Repeat the process if you are installing a second SSD module.
There are two types of M.2 SSD enablement boards available. The single module M.2 SSD enablement
board can support only one SSD module. The dual module M.2 SSD enablement board can support
one or two SSD modules. The installation procedures below apply to both the single and dual module
M.2 enablement boards while the images below represent the dual module M.2 SSD enablement
board.
7.
Install the M.2 SSD enablement board with installed SSD modules into the PCI riser cage, and then
connect the SATA cables to the enablement board.
Summary of Contents for ProLiant DL160 Gen9
