HP PROCURVE 2910AL, Access Security Manual

Page: 376 / 594

IPv4 Access Control Lists (ACLs)
Displaying ACL Configuration Data
Display Static Port ACL Assignments
This command briefly lists the identification and type(s) of current static port
ACL assignments to individual switch ports and trunks, as configured in the
running-config file. (The switch allows one static port ACL assignment per
port.)
Syntax: show access-list ports < all | interface >
Lists the current static port ACL assignments for ports and
trunks in the running config file.
N o t e
This information also appears in the
show running
display. If you execute
write
memory
after configuring an ACL, it appears in the
show config
display.
For example, if you assigned a standard ACL with an ACL-ID of “Port-10” to
filter inbound IP traffic on switch ports B10-B11 and trunk trk1, you could
verify these assignments as shown in figure 9-29.
ProCurve(config)# show access-list ports all
Access Lists for Port B10
Inbound : 15
Type : Standard
Access Lists for Port B11
Indicates that a standard ACL
with the ID of “15” is assigned
Inbound : 15
to filter traffic entering the
switch on ports B10 and B11,
and on trunk Trk1.
Type : Standard
Access Lists for Port Trk1
Inbound : 15
Type : Standard
Figure 9-29. Example of Listing the ACL Assignments for Ports and Trunks
9-88